$49.95
– Sold Out| /
Make your garage smart with minimal effort and cash. Just attach the tilt sensor to your garage door and connect the ZEN16 to your existing door switch on the wall. You can control up to 3 doors with a single ZEN16 independently (but you'll need to get additional sensors to monitor them). Scroll down to the "Works with" section for dedicated hub instructions.
You don't need to touch any wiring at the garage opener. Just take the 2 wires from the door switch and attach them to the R1 terminals on the ZEN16. Connect the switch to the Sw1 terminals with another 2 wires, power the ZEN16 up and you're all set. Please make sure your existing opener doesn't have any smart or electronic features and is controlled by a simple momentary wall switch before buying.
NOTE: If you don't see your Z-Wave controller on the list above, please contact us before you purchase this kit.
DC:
OR USB:
Works perfect!
I used this relay for my garage door opener, and it works like a charm. I love the functionality that it brings when combined with the tilt sensor to get an accurate picture of the status of the garage. I only wish it supported S2 access control level security, since it’s a point of entry to the house. From what I could see, it doesn’t appear to support this. Otherwise, still quite satisfied with this and all my Zooz products.
I bought this for my 1 car garage so it has way more connectivity than I'll ever need. Works great with Home Assistant, I soldered some leads to my opener switch and ran it to the box. No issues at all, very useful to see state of garage and have automations to close it at night.
I have 3 car garage and dumb openers that can be open with just short the two wire.
This relay is perfect for the job. arrived fast, easy to wire, sensor works well with it together.
I have HA setup and everything works perfectly together.
Zooz DIY Smart Garage Opener Kit (MultiRelay ZEN16 VER. 2.0 + Tilt Sensor ZSE43)
